User Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the ZQ300 Series
- Unpacking and Inspection
- Reporting Damage
- Features Overview
- Getting Ready to Print
- Battery
- Installing/Removing Battery & Battery Tape Insulator
- Battery Tape Insulator
- Battery Safety
- Charger Safety
- Designing Labels
- Using Pre-Printed Receipt Media
- Loading the Media
- Media Spacers
- Operator Controls
- Forced Download Description and LED Behavior
- Power Save Mode
- Draft Mode
- Verify the Printer Is Working
- Cable Communication
- Wireless Communications with Bluetooth
- Bluetooth Networking Overview
- NFC Use Cases
- WLAN Overview
- Setting Up the Software
- Wearing the Printer
- Belt Clip
- Adjustable Shoulder Strap
- Soft Case
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- ZQ300 Series Cleaning
- Troubleshooting
- Printer Status Indicators
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Report
- Communications Diagnostics
- Calling Technical Support
- Specifications
- Printing Specifications
- Memory and Communications Specifications
- Media Specifications
- ZPL Bar Code Specifications and Commands
- CPCL and ZPL Font Specifications
- Printing in Chinese Fonts
- USB Type-C to Type-A Communications Cable
- Physical, Environmental and Electrical Specifications
- ZQ300 Series Accessories
- Appendix A
- Serial Number and PCC Number Locations
- Appendix B
- User Interface LED Charging Behavior
- Appendix C
- Battery Disposal
- Product Disposal
- Appendix D
- Appendix E
- Using Zebra.com
- Product Support Contacts
- Index
20
ZQ300 Series User Guide
5-Bay Docking Cradle
Use Case: Settlement Room
The ZQ300 Series 5-Bay Docking Cradle is designed to dock
and charge up to ve (5) ZQ310 and ZQ320 printers simultane-
ously. The 5-bay cradle is benecial for use in settlement rooms
where space and electrical outlets are at a premium and charg-
ing in volume is critical. The 5-bay cradle charges the printer from
empty to full in less than four (4) hours. The user is allowed to op-
erate the printer during charging, although the media compart-
ment is not accessible while the printer is docked.
1. Ensure that the 5-bay cradle has been installed properly per
its instruction manual. Ensure that the power supply is prop-
erly connected and its power indicator LED is on (see be-
low).
2. Slide a printer into any one of the ve docking bays as
shown in Figure 9.
Note • If you are using a shoulder strap, ensure it is pulled away
from the printer when docking on the cradle.
LED
Figure 9 • 5-Bay Docking Cradle