User Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the ZQ300 Series
- Unpacking and Inspection
- Reporting Damage
- Features Overview
- Getting Ready to Print
- Battery
- Installing/Removing Battery & Battery Tape Insulator
- Battery Tape Insulator
- Battery Safety
- Charger Safety
- Designing Labels
- Using Pre-Printed Receipt Media
- Loading the Media
- Media Spacers
- Operator Controls
- Forced Download Description and LED Behavior
- Power Save Mode
- Draft Mode
- Verify the Printer Is Working
- Cable Communication
- Wireless Communications with Bluetooth
- Bluetooth Networking Overview
- NFC Use Cases
- WLAN Overview
- Setting Up the Software
- Wearing the Printer
- Belt Clip
- Adjustable Shoulder Strap
- Soft Case
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- ZQ300 Series Cleaning
- Troubleshooting
- Printer Status Indicators
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Report
- Communications Diagnostics
- Calling Technical Support
- Specifications
- Printing Specifications
- Memory and Communications Specifications
- Media Specifications
- ZPL Bar Code Specifications and Commands
- CPCL and ZPL Font Specifications
- Printing in Chinese Fonts
- USB Type-C to Type-A Communications Cable
- Physical, Environmental and Electrical Specifications
- ZQ300 Series Accessories
- Appendix A
- Serial Number and PCC Number Locations
- Appendix B
- User Interface LED Charging Behavior
- Appendix C
- Battery Disposal
- Product Disposal
- Appendix D
- Appendix E
- Using Zebra.com
- Product Support Contacts
- Index
16
ZQ300 Series User Guide
Battery Safety
Caution • Avoid accidental short circuiting of any battery.
Allowing battery terminals to contact conductive material will
create a short circuit which could cause burns and other injuries
or could start a re.
Important • Always refer to the Important Safety Information
data sheet shipped with each printer and the Technical
Bulletin shipped with each battery pack. These documents
detail procedures to ensure maximum reliability and safety
while using this printer.
Important • Always dispose of used batteries properly. Refer to
Appendix E for more battery recycling information.
Caution • Use of any charger not approved specically by Zebra
for use with its batteries could cause damage to the battery
pack or the printer and will void the warranty.
Caution • Do not incinerate, disassemble, short circuit, or
expose to temperatures higher than 65
o
C (149
o
F).
Charger Safety
Do not place any charger in locations where liquids or metallic
objects may be dropped into the charging bays.