User Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the ZQ210 Printer
- Printer Overview
- Getting Ready to Print
- Battery
- Removing the Battery
- Installing the Battery
- Battery Safety
- Charger Safety
- Charging the Battery
- AC-to-USB Charger
- AC-to-USB Charger (cont.)
- Loading Media Procedure
- Operator Controls
- Standard User Controls
- LCD Control Panel
- Information Screen
- Configuration Screen
- Buttons
- Power-Up Sequences
- Verify the Printer is Working
- Printing a Configuration Report
- Connecting the Printer
- Communication to the Printer
- USB Communications
- Zebra Setup Utilities
- Wireless Communications with Bluetooth
- Bluetooth Networking Overview
- Bluetooth Security Modes
- Bluetooth Minimum Security Modes
- Setting Up the Software
- Designing Labels
- Using Pre-Printed Receipt Media
- Black Mark Dimensions (Receipt Media)
- Label Areas
- Label Design Examples
- Keep-Out Areas
- Near Field Communication (NFC)
- NFC Use Cases
- Wearing the Printer
- Swivel Belt Clip
- Soft Case
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- LCD Control Panel Indicators
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Label
- Communications Diagnostics
- Specifications
- Appendix A
- Appendix B
- Appendix C
- Appendix D
- Appendix E
- Appendix F
- Appendix G
- Appendix H
- Index
23
ZQ210 User Guide
Insert the roll of media (in the orientation shown) in the media
compartment. The media roll will be able to spin freely inside the
media compartment.
Figure 4 • Loading Media (cont.)
Close the media cover as shown below and the paper will advance
through the paper path.
Figure 5 • Loading Media (cont.)
Close Media
Cover
Pull Media out of
Printer
Note • Please refer to the Programming Guide (P1099958-001) for
information on changing the setting to adjust the media feed length
via a Set-Get-Do (SGD).