User Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the ZQ210 Printer
- Printer Overview
- Getting Ready to Print
- Battery
- Removing the Battery
- Installing the Battery
- Battery Safety
- Charger Safety
- Charging the Battery
- AC-to-USB Charger
- AC-to-USB Charger (cont.)
- Loading Media Procedure
- Operator Controls
- Standard User Controls
- LCD Control Panel
- Information Screen
- Configuration Screen
- Buttons
- Power-Up Sequences
- Verify the Printer is Working
- Printing a Configuration Report
- Connecting the Printer
- Communication to the Printer
- USB Communications
- Zebra Setup Utilities
- Wireless Communications with Bluetooth
- Bluetooth Networking Overview
- Bluetooth Security Modes
- Bluetooth Minimum Security Modes
- Setting Up the Software
- Designing Labels
- Using Pre-Printed Receipt Media
- Black Mark Dimensions (Receipt Media)
- Label Areas
- Label Design Examples
- Keep-Out Areas
- Near Field Communication (NFC)
- NFC Use Cases
- Wearing the Printer
- Swivel Belt Clip
- Soft Case
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- LCD Control Panel Indicators
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Label
- Communications Diagnostics
- Specifications
- Appendix A
- Appendix B
- Appendix C
- Appendix D
- Appendix E
- Appendix F
- Appendix G
- Appendix H
- Index
19
ZQ210 User Guide
Charging the Battery
AC-to-USB Charger
Install the adapter plug into the Power Supply by hooking the top
edge into the adapter’s receptacle cavity and rotating it until it
snaps into place.
Note • Verify that the adapter plug shipped with your printer is
the correct one for your region.
Note • Batteries that have reached partial charge capacity may
be used. However, it is the recommended that you allow the
batteries to reach a full charge to maintain maximum battery
life.
Important • You must charge the battery fully before using the
printer for the first time.