User Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the ZQ210 Printer
- Printer Overview
- Getting Ready to Print
- Battery
- Removing the Battery
- Installing the Battery
- Battery Safety
- Charger Safety
- Charging the Battery
- AC-to-USB Charger
- AC-to-USB Charger (cont.)
- Loading Media Procedure
- Operator Controls
- Standard User Controls
- LCD Control Panel
- Information Screen
- Configuration Screen
- Buttons
- Power-Up Sequences
- Verify the Printer is Working
- Printing a Configuration Report
- Connecting the Printer
- Communication to the Printer
- USB Communications
- Zebra Setup Utilities
- Wireless Communications with Bluetooth
- Bluetooth Networking Overview
- Bluetooth Security Modes
- Bluetooth Minimum Security Modes
- Setting Up the Software
- Designing Labels
- Using Pre-Printed Receipt Media
- Black Mark Dimensions (Receipt Media)
- Label Areas
- Label Design Examples
- Keep-Out Areas
- Near Field Communication (NFC)
- NFC Use Cases
- Wearing the Printer
- Swivel Belt Clip
- Soft Case
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- LCD Control Panel Indicators
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Label
- Communications Diagnostics
- Specifications
- Appendix A
- Appendix B
- Appendix C
- Appendix D
- Appendix E
- Appendix F
- Appendix G
- Appendix H
- Index
15
ZQ210 User Guide
Getting Ready to Print
Battery
Installing/Removing Battery
Important • Batteries are shipped with a 70% State of Charge (SOC)
which allows for immediate use of the printer before having to
charge the battery.
Removing the Battery
1. Use a #1 Phillips driver (with or without the belt clip present) to
remove the screw on the battery compartment cover where
indicated.
2. Remove the battery compartment cover (and belt clip if
applicable) to expose the battery.