Technical information

Installation
Internal PSII
PrintServer II User and Reference Guide 19
5 Fold the cable and the ferrite bead back over the mounting bracket, and connect the
ribbon cable connector into the keyed Interface Data Cable Connector (J4) on the
main logic board. Secure the
PSII interface board in place with the cover plate
screws that you removed early in this step sequence.
6 Confirm that all small cable connectors are tight.
7 Reinstall the PAX-Series PCB access panel or the left side-panel of the XiII and
XiIII-Series printers that you removed earlier in this step sequence.
8 This kit includes a label printed with the Ethernet MAC hardware address for the
PSII. Remove the backing from the label and affix it to the back of the printer.
9 Reconnect the AC power cord and turn the printer on.
10 Consult your System Administrator before configuring the
PSII for your network!
To establish the network connection, refer to the section applicable to your
network type.