Quick Start Guide

ManualsBrandsZebra ManualsHardwareZD421t label printer - B/W - thermal transfer

Push the right side of the spool onto the spring-loaded spindle. Place the left side of the spool onto the spindle aligning it with the notches. Pull the supply ribbon leader up and over the printhead and attach it to the

take-up spool.

Turn the ribbon take-up wheel to remove the slack and advance the ribbon.

2 Remove Packing

3 Load Media (continued)

4 Adjust Sensor

4 Adjust Sensor (continued)

ZD421T

Desktop Printer

1 Setup

Quick Start Guide

3 Load Media

5 Load Ribbon

Open the printer and remove the packing.Slide the release latches to the front to unlock the cover. Unroll and discard the outer layer of the media roll.

Spread the roll holders open and place the roll into the printer. Pull the end of the roll past the front edge of the printer.Verify the roll spins easily on the holder. Press the media under the guides. Align the sensor to the center of the roll for regular labels.

Align the sensor to the edge of the roll for marked labels.

Scan the code to download and install Zebra Setup Utilities.

zebra.com/setup

Summary of content (2 pages)

PAGE 1
ZD421T 1 2 Setup 3 Remove Packing Load Media Desktop Printer zebra.com/setup Quick Start Guide 3 Slide the release latches to the front to unlock the cover. Open the printer and remove the packing. Adjust Sensor (continued) Align the sensor to the edge of the roll for marked labels. Unroll and discard the outer layer of the media roll. 4 Load Media (continued) Spread the roll holders open and place the roll into the printer. 4 Scan the code to download and install Zebra Setup Utilities.
PAGE 2
6 7 Close Printer Push down on the front edge of the printer until it locks. 9 Power On (continued) When the the printer is ready, the printer status light will turn green. 8 Connect Power A. Plug the power supply into the printer. B. Plug the power cable into the power supply. C. Plug the power cord into an appropriate receptacle. D. The power supply lights green. 10 11 Smart Calibration Press and hold the Pause and Cancel buttons for two seconds to line up the labels.