User Manual

Setup for Windows
®
OS
206
Test Printing with Zebra Setup Utility:
1. Open the Zebra Setup Utility.
2. Click on the newly installed printer’s icon to select the printer and activate the printer configuration
buttons below it in the window.
3. Click the Open Printer Tools button.
4. In the Print tab window, click on the Print configuration label line and then click on the Send button.
The printer should print a configuration report.
Test Printing with Windows Printer and Faxes menu:
1. Click on the Windows Start menu button to access the Printers and Faxes menu or Control Panel to
access the Printers and Faxes menu. Open the menu.
2. Select the newly installed printer’s icon to select the printer and right-click the mouse to access the
printer Properties menu.
3. From the printer’s General tab window, click on the Print Test Page button. The printer should print a
Windows test print page.
Test Print with an Ethernet printer connected to a network
Test Print on an Ethernet printer connected to a network (LAN or WLAN) with a (MS-DOS) Command
Prompt (or Run from the Windows XP Start menu):
1. Create a text file with the following ASCII three characters: ~WC
2. Save the file as: TEST.ZPL (an arbitrary file name and extension name).
3. Read the IP address off the printer’s Configuration Reports Network Status printout. On a system that is
connected to the same LAN or WAN as the printer, type the following in the Web browser address bar
and enter: ftp (IPaddress).
For IP address 123.45.67.01 it would be:
ftp123.45.67.01
4. Type the word put’ followed by the file name and enter. For this test print file, it would be:
putTEST.ZPL
The printer should print a new Print Configuration Report.