User Manual

ZPL Configuration
Command Listing Name Description
— USB COMM. Connection Status: Connected / Not Connected
^SCa BAUD Default: 9600
^SC,b DATA BITS Default: 8 BITS
^SC,,c PARITY Default: NONE
^SC,,,,e HOST HANDSHAKE Default: AUTO ^SC,,,,
^SC,,,,,f PROTOCOL Default: NONE
— SGD —** COMMUNICATIONS Default: NORMAL MODE
SER COMM. MODE Default: AUTO
^CT / ~CT CONTROL CHAR Default: <~> 7EH
^CC / ~CC COMMAND CHAR Default: ^> 5EH
^CD / ~CD DELIM./CHAR Default: <,> 2CH
^SZ ZPL MODE Default: ZPL II
— SGD —** COMMAND OVERRIDE Default: INACTIVE
^MFa MEDIA POWER UP Default: NO MOTION
^MF,b HEAD CLOSE Default: FEED
~JS BACKFEED Default: DEFAULT
^LT LABEL TOP Default: +000
^LS LEFT POSITION Default: +0000
~JD / ~JE HEXDUMP Default: NO (~JE)
Default: DISABLED Default: DISABLED
From this point in the Configuration Receipt listing, the printout has sensor settings and values displayed
to troubleshoot sensor and media operations. These are typically used by Zebra Tech Support to diagnose
printer problems.
** - Not supported with a ZPL command, uses the Set Get Do command in the ZPL manual. See
device.command_override.xxxxx in the ZPL Programmer’s manual.
The configuration settings listed here resume after the TAKE LABEL sensor value. These listings contain
printer features seldom changed from default or provide status information.
Command Listing Name Description
MODES ENABLED Default:CWF(See ^MP Command)^MP
MODES DISABLED Default: (nothing set)
^JM RESOLUTION Default: 448 8/mm (203 dpi); 640 12/mm (300 dpi)
— FIRMWARE Lists ZPL Firmware Version
— XML SCHEMA 1.3
— HARDWARE ID Lists Firmware Boot-block Version
LINK-OS VERSION
— CONFIGURATION CUSTOMIZED (after first use)
181