User Manual
Table Of Contents
- Terms of Use
- Publication Date
- About
- Contents
- Introduction
- Printer Features
- Controls and Indicators
- Setup
- Printer Setup Overview
- Select a Location for the Printer
- Attaching Power
- Getting Ready to Print
- Loading Roll Media
- Run a SmartCal Media Calibration
- Test Printing with the Configuration Report
- Detecting a Media Out Condition
- Connecting your Printer to a Computer
- Wi-Fi and Bluetooth Classic Wireless Connectivity Option
- Setup for Windows® OS
- Print Operations
- Maintenance
- Troubleshooting
- Interface Connector Wiring
- Dimensions
- Media
- ZPL Configuration
Troubleshooting
96
Manual Calibration
Manual calibration is recommended whenever you are using pre-printed media or if the printer will not
correctly auto calibrate.
1. Make sure media is loaded. A good common label size is 4 by 6 inches.
2. Turn on the printer power.
3. Send the following command to the printer: ! U1 do "ezpl.manual_calibration" ""
See Sending Files to the Printer.
4. The printer will set the media sensor for the label backing being used. After it is done making this
adjustment, the roll will automatically feed (advance) until a label is positioned at the printhead. A profile
of the media sensor settings (similar to the example below) will print. Upon completion, the printer will
save the new settings in memory and the printer is ready for normal operation.
Start of several labels
End of several labels