Manualshelf

Quick Start Guide

ManualsBrandsZebra ManualsHardwareZD200 Series ZD230 label printer - B/W - direct thermal
123
Power On and Print
Set Up Your Printer
Load Media
Connect the Power Supply.
Open and place roll on holder. Push the paper under guides. Align sensor near center (default).
Press and release Power Button. Lights will cycle. Printer Ready when Status Light is steady Green.
Connect a USB cable to the printer.
Remove and discard outer layer
Perform Media Calibration
:
Press and hold the FEED button until the Status
Light blinks off and on TWICE, then release.
Test Print Configuration Report
:
Press and hold the FEED button until the Status
Light blinks off and on ONCE, then release.