User Manual
Table Of Contents
- Terms of Use
- Publication Date
- About
- Contents
- Introduction
- Printer Features
- Controls and Indicators
- Setup
- Printer Setup Overview
- Select a Location for the Printer
- Attaching Power
- Getting Ready to Print
- Loading Roll Media
- Run a SmartCal Media Calibration
- Test Printing with the Configuration Report
- Detecting a Media Out Condition
- Connecting your Printer to a Computer
- Wi-Fi and Bluetooth Classic Wireless Connectivity Option
- Setup for Windows® OS
- Print Operations
- Maintenance
- Troubleshooting
- Interface Connector Wiring
- Dimensions
- Media
- ZPL Configuration
Maintenance
77
Cleaning the Cutter and Label Dispenser Options
This is a continuation of cleaning the media path for either option, if installed.
Cutter Option Cleaning
The plastic media path surfaces can be cleaned but not the internal cutter blades or mechanism.
Important • The cutter blade mechanism does not require maintenance cleaning. DO NOT clean the blade. This
blade has a special coating to resist adhesives and wear.
Cut Warning • There are no operator serviceable parts in the cutter unit. Never remove the cutter cover (bezel). Never
attempt to insert objects or fingers in to the cutter mechanism.
Note • Using unapproved tools, cotton swabs, solvents (including alcohol), etc. all may damage or shorten the cutter’s
usable life or cause the cutter to jam.
1. Wipe the ridges and the plastic surfaces of the media entry (inside) and exit slot (outside) of the cutter.
Clean inside the areas outlined in blue.
2. Repeat as necessary to remove any adhesive or contaminate residue after it dries.