User guide

97
ZPL Commands for Wireless Operation
^ND
4/29/08 Wireless User Guide 14143L-005 Rev. A
^ND
Change Network Settings
Description The ^ND command changes the network settings on Zebra ZM400/ZM600™
and S4M™ printers running V53.15.xZ or later or on RZ400/RZ600™ printers running
R53.16.x or later.
For the external wired print server settings, the ^ND command is the same as the ^NS
command. For the wireless print server settings, the ^ND command is the same as the ^WI
command.
Format ^NDa,b,c,d,e,f,g,h,i,j
This table identifies the parameters for this format:
Parameters Details
a = the device that is
being modified
Accepted Values:
1 = external wired
2 = internal wired *
3 = wireless
b = IP resolution Accepted Values:
A =All
B =BOOTP
C = DHCP and BOOTP
D = DHCP
G = Gleaning only (Not recommended when the Wireless
Print Server or Wireless Plus Print Server is installed.)
R =RARP
P = Permanent
Default Value: A
c = IP address
Accepted Values: Any properly formatted IP address in the
xxx.xxx.xxx.xxx format.
d = subnet mask Accepted Values: Any properly formatted subnet mask in the
xxx.xxx.xxx.xxx format.
e = default gateway Accepted Values: Any properly formatted gateway in the
xxx.xxx.xxx.xxx format.
f = WINS server
address
Accepted Values: Any properly formatted WINS server in the
xxx.xxx.xxx.xxx format.
g = connection
timeout checking
Accepted Values:
Y = yes
N = no
Default Value: Y
h = timeout value
Time, in seconds, before the connection times out.
Accepted Values: 0 through 9999
Default Value: 300