User guide

ZPL Commands for Wireless Operation

^NC

14143L-005 Rev. A Wireless User Guide 4/29/08

^NC

Select the Primary Network Device

Description The ^NC command selects the wired or wireless print server as the primary

network device. This command is supported only on Zebra ZM400/ZM600™ and

RZ400/RZ600™ printers.

The ZM400, ZM600, RZ400, and RZ600 printers support the simultaneous installation of an

internal, external, and a wireless print server. Even though all three print servers may be

installed, only one is connected to the network and is the active print server. Table 21 outlines

priorities and identifies which device becomes the active print server when multiple print

servers are installed.

Format ^NCa

This table identifies the parameters for this format:

Table 21 • Effect of Primary Network Setting on Active Print Server

If the

Primary

Network is

set to:

Installed and Connected to

a Live Ethernet Network Then, the Active

Print Server will be:

Internal External Wireless*

Wired

X X X Internal

XX External

XWireless

Wireless

XX X Wireless

X X Internal

X External

* NOTE: A wireless option board must have an active radio that can properly associate to an access point.

Parameters Details

a = primary network

device

Accepted Values:

1 = wired primary

2 = wireless primary

Default Value: 1

must be an accepted value or it is ignored