User guide

95
ZPL Commands for Wireless Operation
^NB
4/29/08 Wireless User Guide 14143L-005 Rev. A
^NB
Search for Wired Print Server during Network Boot
Description Use this command to tell the printer whether to search for a wired print server
at bootup. This command is ignored on the Zebra ZM400, ZM600, RZ400, and RZ600
printers.
Table 20 identifies which device becomes the active print server under different conditions.
Format ^NBa
The following table identifies the parameters for this format.
Note • Only one print server can be installed in the S4M at one time, so this check does not
occur.
Table 20 • Results of Check for Wired Print Server
If the Check
for Wired Print
Server is
set to:
Installed and Connected to
a Live Ethernet Network Then, the Active Print
Server will be:
Wired Wireless*
Skip
XX Wireless
XWired
XWireless
Check
XX Wired
XWired
XWireless
* NOTE: A wireless option board must have an active radio that can properly associate to an access point.
Parameters Details
a = check for wired print
server at boot time
Accepted Values: C (CHECK), S (SKIP CHECK)
Default Value: S