User guide

Wireless Status and Settings

Restore Network Parameters to Defaults

4/29/08 Wireless User Guide 14143L-005 Rev. A

Restore Network Parameters to Defaults

You may need to restore the network parameters to the factory defaults under the following

circumstances:

• If you download a different version of firmware to your printer

• If you need to reset the encryption keys (for instances where a key was entered incorrectly

or was forgotten)

After you return the network parameters to the defaults, you must reconfigure your printer to

use the wireless print server (see Configuration on page 29). If you saved the ZPL script

generated by the Wireless Setup Wizard, simply send this file to the printer, and then power

cycle the printer. If you were using a wireless password, you must set it again (see ^WP

on page 110).

You can set the network parameters back to the factory defaults in two ways:

•The Restore Default Network Configuration button on the printer’s View and Modify

Printer Settings Page (see Figure 9 on page 67).

•The

DEFAULT NET option, which appears as an option when you exit Setup mode. Refer

to the user guide for your printer for specific instructions on how to modify the control

panel parameters.

Note • The LOAD DEFAULTS option and the Restore Default Configuration button reset

all printer parameters other than network settings back to factory defaults. The network

settings will not change when these options are selected.