User guide

Wireless Status and Settings

View or Change Wireless Parameters on the LCD

14143L-005 Rev. A Wireless User Guide 4/29/08

CHANGE GATEWAY

View or Change the Gateway

This parameter can be modified only when

PERMANENT is selected for

OBTAIN IP ADDRESS.

Selections: 0 to 255 for each field

Default Value: 0.0.0.0

Note • Leading zeroes are not shown in the address. If an IP address

contains more digits than can be displayed at one time, use the left

or right arrows to scroll through the digits.

Password Level 4 Parameters

MAC ADDRESS

2,3

View the Wireless Radio Card’s MAC Address

Each wireless radio card has a permanent and unique Media Access

Control (MAC) address assigned to it. This parameter shows the MAC

address for the current wireless radio card.

Default Value: 000000000000

ESSID

2,3

View the ESSID Value

The Extended Service Set Identification (ESSID) is an identifier for your

wireless network. This parameter shows the ESSID for the current wireless

configuration.

Default Value: 125

WLAN SECURITY

1,3

View the WLAN Security Type

This parameter displays the current security type. To change the value

shown, use ^WX on page 115 or wlan.security on page 192.

RESET NETWORK

1,3

Reset the Wired or Wireless Network

Use this parameter to reinitialize the wireless radio card and the print server

(wired or wireless) when the wireless print server is running. This

parameter also causes any wireless radio card in the printer to reassociate to

the wireless network. (Same function as ZPL command ~WR on page 112.)

Table 12 • Wireless Parameters for V50.15.x or V53.15.x Firmware (S4M Printer) (Continued)

Parameter Explanation

1 Appears after the printer recognizes the existence of a ZebraNet print server (wired or wireless). All zeroes

(000.000.000.000) display until the printer obtains an IP address or defaults to address 192.168.254.254.

2 Appears only when the ZebraNet Wireless Print Server is installed.

3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.