User guide

53
Wireless Status and Settings
View or Change Wireless Parameters on the LCD
4/29/08 Wireless User Guide 14143L-005 Rev. A
Parameters for V50.15.x or V53.15.x Firmware (S4M Printer)
Table 12 shows the wireless parameters that may be viewed or modified through the S4M
control panel. To view wireless and network parameters that are not available as selections
through the control panel, print a network configuration label.
Note • Refer to the S4M User Guide for specific instructions on how to use the control panel.
Table 12 • Wireless Parameters for V50.15.x or V53.15.x Firmware (S4M Printer)
Parameter Explanation
Password Level 3 Parameters
OBTAIN IP ADDRESS
1
Obtain an IP Address
Selects the method by which an IP address will be assigned to the printer. If
you choose
AUTO SELECT, you may specify an IP protocol.
Selections: AUTO SELECT (dynamic), PERMANENT (user-specified)
Default Value: AUTO SELECT
CHANGE IP PROTOCOL
1
View or Change the IP Protocol
Determines the method(s) by which the print server (wired or wireless)
receives the IP address from the server.
This parameter can be modified only when
AUTO SELECT is selected for
OBTAIN IP ADDRESS.
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP,
DHCP AND BOOT
Default Value: ALL
CHANGE IP ADDRESS
1
View or Change the Printer’s IP Address
This parameter can be modified only when
PERMANENT is selected for
OBTAIN IP ADDRESS.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note • Leading zeroes are not shown in the address. If an IP address
contains more digits than can be displayed at one time, use the left
or right arrows to scroll through the digits.
CHANGE SUBNET
1
View or Change the Subnet
This parameter can be modified only when
PERMANENT is selected for
OBTAIN IP ADDRESS.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note • Leading zeroes are not shown in the address. If an IP address
contains more digits than can be displayed at one time, use the left
or right arrows to scroll through the digits.
1 Appears after the printer recognizes the existence of a ZebraNet print server (wired or wireless). All zeroes
(000.000.000.000) display until the printer obtains an IP address or defaults to address 192.168.254.254.
2 Appears only when the ZebraNet Wireless Print Server is installed.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.