User guide

Wireless Status and Settings
View or Change Wireless Parameters on the LCD
50
14143L-005 Rev. A Wireless User Guide 4/29/08
Parameters for V53.15.x, R53.16.x, or later Firmware
(ZM400, ZM600, RZ400, and RZ600 Printers)
Firmware Requirements Table 11 shows the wireless parameters that may be viewed or
modified through the printer’s control panel.
Wireless Password Some of the parameters can be password-protected by a wireless
password. By default, the wireless print servers run in an “unprotected” mode (password set to
0000), which means that you do not need to enter a wireless password through the control
panel to view or modify wireless settings. To set a wireless password (not the same as the
general printer password), use the
^WP ZPL command.
Table 11 • Wireless Parameters for V53.15.x and R53.16.x Firmware
(ZM400, ZM600, RZ400, and RZ600 Printers)
Parameter
Function
PRIMARY NETWORK
1
Select the Primary Network Device
This parameter tells if the printer uses IP settings from the wireless or a
wired print server at bootup.
Selections: WIRED, WIRELESS
Default Value: WIRED
LOAD FROM EXT?
1
View if IP Settings Are Loaded from the Printer or Print Server
This parameter tells if the printer should use IP settings from the external
print server at bootup.
Selections: YES, NO
Default Value: NO
ACTIVE PRINTSRVR
1
View the Active Print Server
This menu item displays which print server is being used. This tells which
device’s settings such as IP protocol and IP address are being displayed
under those menu items.
Selections:
• WIRELESS indicates that the wireless device is active.
• INTERNAL WIRED indicates that the internal 10/100 option board is
active.
• EXTERNAL WIRED indicates that the external print server is active.
• NONE indicates that at least one of the network options is installed but
none of them are active. When NONE is shown for this menu item, the
device-specific items such as IP protocol and IP address will not display.
Default Value: NONE
IP PROTOCOL
2
View or Change the Method to Obtain an IP Address
This parameter tells if the user (permanent) or the server (dynamic) selects
the IP address. If a dynamic option is chosen, this parameter tells the
method(s) by which the print server (wired or wireless) receives the IP
address from the server.
Selections: ALL, BOOTP, DHCP, DHCP AND BOOTP, PERMANENT
Default Value: All