User guide

49
Wireless Status and Settings
View or Change Wireless Parameters on the LCD
4/29/08 Wireless User Guide 14143L-005 Rev. A
LOAD LAN FROM?
1
View if IP Settings Are Loaded from the Printer or Print Server
This parameter, which serves the same function as the
^NP ZPL command,
tells if the printer uses IP settings from the printer or the print server at
bootup.
Selections: PRINTER, PRINTSERVER
Default Value: PRINTER
IP PROTOCOL
2
View or Change the Method to Obtain an IP Address
This parameter tells if the user (permanent) or the server (dynamic) selects
the IP address. If a dynamic option is chosen, this parameter tells the
method(s) by which the print server (wired or wireless) receives the IP
address from the server.
Selections: ALL, BOOTP, DHCP, DHCP AND BOOTP, PERMANENT
Default Value: All
IP ADDRESS
2
View the Printer’s IP Address
Default Value: 0.0.0.0
SUBNET MASK
2
View the Subnet
Default Value: 255.255.255.0
DEFAULT GATEWAY
2
View the Gateway
Default Value: 0.0.0.0
MAC ADDRESS
2,3
View the Wireless Radio Card’s MAC Address
Each wireless radio card has a permanent and unique Media Access Control
(MAC) address assigned to it. This parameter shows the MAC address for
the current wireless radio card.
Default Value: 000000000000
ESSID
1,2,3
View the ESSID Value
The Extended Service Set Identification (ESSID) is an identifier for your
wireless network. This parameter shows the ESSID for the current wireless
configuration.
Default Value: 125
WLAN SECURITY
1,3
View the WLAN Security Type
This parameter displays the current security type. To change the value
shown, use ^WX on page 115 or wlan.security on page 192.
RESET NETWORK
1,3
Reset the Wired or Wireless Network
Use this parameter to reinitialize the wireless radio card and the print server
(wired or wireless) when the wireless print server is running. This
parameter also causes any wireless radio card in the printer to reassociate to
the wireless network. (Same function as ZPL command ~WR on page 112.)
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 Appears after the printer recognizes the existence of a ZebraNet print server (wired or wireless). All zeroes
(000.000.000.000) display until the printer obtains an IP address or defaults to address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
Table 10 • Wireless Parameters for V60.15.x, R6x.15.x, ZSPx, or later Firmware (Continued)
Parameter
Function