User guide

Wireless Status and Settings

View or Change Wireless Parameters on the LCD

14143L-005 Rev. A Wireless User Guide 4/29/08

View or Change Wireless Parameters on the LCD

Refer to the user guide for your printer for specific instructions on how to modify the control

panel parameters.

The control panel parameters are somewhat different for different printers.

• For the 105SL, PA X 4, R110PA X 4, R4Mplus, R110Xi, R170Xi, R110Xi HF, XiIIIPlus,

Z4Mplus, and Z6Mplus, see Parameters for V60.15.x, R6x.15.x, ZSPx, or later Firmware

on page 48.

• For the ZM400, ZM600, RZ400, and RZ600, see Parameters for V53.15.x, R53.16.x, or

later Firmware (ZM400, ZM600, RZ400, and RZ600 Printers) on page 50.

• For the S4M printer, see Parameters for V50.15.x or V53.15.x Firmware (S4M Printer)

on page 53.

Parameters for V60.15.x, R6x.15.x, ZSPx, or later Firmware

Firmware Requirements Table 10 shows the wireless parameters that may be viewed or

modified through the printer’s control panel. These parameters appear on printers with

firmware V60.15.x, R6x.16.x, or later, and the following special firmware releases: ZSP994P,

ZSP999F, ZSP1027F, ZSP1056E, ZSP1082F, or later.

Printers with older versions of firmware have a different set of parameters. For those

parameters, refer to the ZebraNet Wireless Print Server User Guide. You may download

firmware V60.15.x, R6x.15.x, or later to access the newer encryption features. Go to

http://www.zebra.com/firmware for firmware download options.

Wireless Password Some of the parameters can be password-protected by a wireless

password. By default, the wireless print servers run in an “unprotected” mode (password set to

0000), which means that you do not need to enter a wireless password through the control

panel to view or modify wireless settings. To set a wireless password (not the same as the

general printer password), use the

^WP ZPL command.

Note • The HC100 does not have an LCD. To view or change the wireless parameters, use

the printer’s web pages, ZPL commands, or SGD commands.

Table 10 • Wireless Parameters for V60.15.x, R6x.15.x, ZSPx, or later Firmware

Parameter

Function

WIRED PS CHECK?

View if the Printer Checks for a Wired Print Server at Bootup

This parameter, which serves the same function as the

^NB ZPL command,

tells if the printer searches for a wired print server at bootup.

Selections: YES, NO

Default Value: NO