User guide

Introduction

Determining the Active Print Server

4/29/08 Wireless User Guide 14143L-005 Rev. A

Select the Primary Network Device (ZM400, ZM600, RZ400, and RZ600 only)

The ZM400, ZM600, RZ400, and RZ600 printers support the simultaneous installation of an

internal, external, and a wireless print server. Even though all three print servers may be

installed, only one is connected to the network and is the active print server. Table 6 outlines

priorities and identifies which device becomes the active print server when multiple print

servers are installed.

You can select whether the wired or wireless print server will be the primary connection using

one of the following:

•the PRIMARY NETWORK parameter on the control panel (see Table 11, Wireless

Parameters for V53.15.x and R53.16.x Firmware (ZM400, ZM600, RZ400, and RZ600

Printers) on page 50)

•the ^NC ZPL command (see ^NC on page 96)

• the Primary/Secondary settings web page (see Primary/Secondary Settings on page 73)

Table 6 • Active Print Server

If the

Primary

Network is

set to:

Installed and Connected to

a Live Ethernet Network Then the Active

Print Server will be:

Internal External Wireless*

Wired

X X X Internal

XX External

XWireless

Wireless

XX X Wireless

X X Internal

X External

* NOTE: A wireless option board must have an active radio that can properly associate to an access point.