User guide

223
Index
4/29/08 Wireless User Guide 14143L-005 Rev. A
L
LEAP mode
setting using ZPL, 108
liability, 2
Line Printer Daemon (LPD) protocol setting, 143
link status indicator, 44
LIST NETWORK option, 46
M
MAC address
retrieve via card.mac_addr, 130
retrieve via wlan.mac_addr, 185
view on other printers, 49
view on the S4M, 54
view on ZM and RZ printers, 51
memory locations, 78
N
^NB, network boot, 95
network boot command, 95
network configuration label
HC100 printer configuration wristband, 47
print through control panel, 46
print via ZPL, 109
network configuration screens, 72
network operating mode, 186
network settings
change via control panel, 48
setting via ZPL, 106
Network Setup Wizard, 31
^NN, set SNMP parameters, 99
NO CARD INSERTED message, 58
noise level
indicator, 45
view via wlan.signal.noise, 201
NOT ASSOCIATED message, 58
NOT AUTHENTICATD message, 58
^NP, set primary/secondary device, 100
^NT, set SMTP, 101
^NW, set web authentication timeout value, 102
O
onboard flash, 78
option 61
CID prefix, 136, 170
enable, 135, 169
P
parallel port to configure wireless print server, 30
pass phrase, 34
password
affect of wireless password on control panel
parameters, 48, 50
private key password, 189
set wireless password via wlan.password, 187
set wireless password via ^WP, 110
poor signal setting, 58
POP3
change poll interval, 147
enable mailbox, 145
IP address, 148
mailbox password, 146
user name, 149
pre-shared key (PSK) value, 215
primary network device
preference for active print server, 26
select for ZM and RZ printers, 50
selection by ^NC, 96
primary/secondary device
setting via web pages, 73
setting via ZPL, 100
print network configuration label
through control panel, 46
via ZPL command, 109
PRINT OUT NETWORK option, 46
printer compatibility, 17
printer home page, 64
printer IP address, 166
printer memory, 78
printer web pages
RFID setup, 69
private key password, 189
R
RADIO WARNING POOR SIGNAL message, 58
RESET NETWORK option
other printers, 49
S4M, 54
ZM and RZ printers, 52
reset wireless radio card and print server, 112
restore network to defaults
options for restoring, 55
reconfiguring using Network Setup Wizard, 31
RFID setup web page, 69
roam interval, 190
roam signal, 191