User guide

173
SGD Commands for Wireless Operation
wlan.ip.gateway
4/29/08 Wireless User Guide 14143L-005 Rev. A
wlan.ip.gateway
Description This command instructs the printer to change the wireless print server’s
gateway address.
Type getvar; setvar
This table identifies the commands for this format:
Note • This setting refers to the gateway address. A set value is ignored if the IP protocol is
not set to permanent.
Commands Details
getvar
This command instructs the printer to respond with the wireless printer
server’s gateway address.
Format:
! U1 getvar "wlan.ip.gateway"
setvar
This command instructs the printer to change the wireless printer server’s
gateway address.
Format: ! U1 setvar "wlan.ip.gateway" "value"
Va lues : Any valid gateway address
Default: "0.0.0.0"
Example • This setvar example shows the value set to "10.3.5.1".
! U1 setvar "wlan.ip.gateway" "10.3.5.1"
When the setvar value is set to "10.3.5.1", the getvar result is "10.3.5.1".