User guide

SGD Commands for Wireless Operation
wlan.ip.addr
166
14143L-005 Rev. A Wireless User Guide 4/29/08
wlan.ip.addr
Description This command allows you to get or set the wireless print servers’s IP address.
Type getvar; setvar
This table identifies the commands for this format:
Important • For a set IP address to take affect, the IP protocol must be set to permanent and
the print server must be reset.
Commands Details
getvar
This command instructs the printer to respond with its current wireless
print server IP address.
Format: ! U1 getvar "wlan.ip.addr"
setvar
This command instructs the printer to change its current wireless print
server IP address upon powering the printer on.
Format: ! U1 setvar "wlan.ip.addr" "value"
Va lues : any valid IP address
Default: "0.0.0.0"
Note • The setvar value of this command can be affected by the
wlan.ip.dhcp.enable command.
Example • This setvar example shows the value set to "10.14.4.235".
! U1 setvar "wlan.ip.addr" "10.14.4.235"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"10.14.4.235".