User guide

141
SGD Commands for Wireless Operation
ip.gateway
4/29/08 Wireless User Guide 14143L-005 Rev. A
ip.gateway
Description This command instructs the printer to change the gateway address.
Type getvar; setvar
This table identifies the commands for this format:
Important • This setting refers to the gateway address. A set value is ignored if the IP
protocol is not set to permanent.
Commands Details
getvar
This command instructs the printer to respond with the gateway address.
Format: ! U1 getvar "ip.gateway"
setvar
This command instructs the printer to change the gateway address.
Format: ! U1 setvar "ip.gateway" "value"
Va lues : Any valid gateway address
Default: "0.0.0.0"
Example • This setvar example shows the value set to "10.3.5.1".
! U1 setvar "ip.gateway" "10.3.5.1"
When the setvar value is set to "10.3.5.1", the getvar result is "10.3.5.1".