User guide

4/29/08 Wireless User Guide 14143L-005 Rev. A
7
SGD Wireless Commands
This chapter provides a high-level overview of the wireless Set / Get / Do (SGD) commands
and details on each SGD command.
For printer support of SGD commands, see the ZPL II Progrmming Guide. A copy of this
manual is available at http://www.zebra.com/manuals or on the user CD that came with your
printer.
SGD commands are available in printers with firmware version V60.15.x, V50.15.x,
V61.15.x, V56.15.x, V53.15.xZ, V54.15.x, R60.15.x, R62.15.x, R63.15.x, R65.15.x, or later.
Important • These are important points to note when using ZPL and SGD commands:
• SGD commands are case-sensitive.
• ZPL and SGD commands should be sent to the printer as separate files.
• Certain settings can be controlled by both ZPL and SGD. Configuration changes made in
ZPL can affect configuration changes made in SGD.
• Changes made with one command type (ZPL or SGD) will affect the data returned to the
host in response to both ZPL and getvar commands. The command type (ZPL or SGD)
that was sent last determines the current setting.
• Some RF cards do not support all of the SGD commands.