User guide

119
ZPL Commands for Wireless Operation
^WX
4/29/08 Wireless User Guide 14143L-005 Rev. A
Supporting Parameters for Different Security Types
The supporting parameters required for this command vary based on the security type that you
select. You should not use all of the supporting parameters each time that you use this
command, nor will you use extra commas to separate unused fields. Follow the example and
format for your specific security type in this section, substituting your own wireless network
data.
Security Type 01: No Wireless Security Active
Format ^WX01
Security Type 02: WEP 40-Bit
Format ^WX02,b,c,d,e,f,g,h
Security Type 03: WEP 128-Bit
Format ^WX03,b,c,d,e,f,g,h
Example • This example turns off all wireless securities controlled under this command, but
it does not reset the printer’s wireless settings to their defaults. To reset all wireless settings,
see Restore Network Parameters to Defaults on page 55.
^XA
^WX01
^JUS^XZ
Example • This example configures the printer for WEP 40-bit encryption using index
key 1, open authentication, and a hexadecimal WEP key with a value of “
A1B2C3D4F5.”
^XA
^WX02,1,O,H,A1B2C3D4F5,,,
^JUS
^XZ
Example • This example configures the printer for WEP 128-bit encryption using index
key 2, open authentication, and four hexadecimal WEP keys.
^XA
^WX03,2,O,H,001122334455667788,112233445566778899,223344
556677889900,334455667788990011
^JUS
^XZ