User guide

ZPL Commands for Wireless Operation
^WX
118
14143L-005 Rev. A Wireless User Guide 4/29/08
j = password*
Specifies a password for security types that require one.
A
value must be specified if using the following security
types:
• EAP-TTLS
•LEAP
• WPA LEAP
•PEAP
•WPA PEAP
• WPA EAP-TTLS
•Kerberos
Accepted Values: The actual value for the password.
Default Value: password
k = optional private key
password*
Specifies an optional private key password for security types
that require one.
A value must be specified if using the
following security types:
• EAP-TLS
• EAP-FAST
• WPA EAP-TLS
•WPA EAP-FAST
Accepted Values: The actual value for the optional private
key.
Default Value: None
l = realm*
Specifies the realm for security types that require it. A value
must be specified if using Kerberos.
Accepted Values: The actual value for the realm.
Default Value: kerberos
m = Key Distribution
Center (KDC)*
Specifies the KDC for security types that require it. A value
must be specified if using Kerberos.
Accepted Values: The actual value for the KDC.
Default Value: krbtgt"
n = Pre-Shared Key
(PSK) value*
Enter the PSK value. This value is calculated and must be the
same for each device on the WLAN. Use ZebraNet Bridge to
generate the PSK value. A value must be specified if using
WPA PSK.
Important • Do not enter a pass phrase for this field in
this command. To use a pass phrase, use the ZebraNet
Bridge Enterprise Wireless Setup Wizard (see
Configure Using the Network Setup Wizard on page 31 for
more information).
Accepted Values: a minimum of 64 hexadecimal digits
Default Value: None
Parameters Details
* Not used for all security types