User guide

117
ZPL Commands for Wireless Operation
^WX
4/29/08 Wireless User Guide 14143L-005 Rev. A
e,f,g,h =
WEP
encryption keys
1 through 4*
Specifies the actual values of any WEP encryption keys to be
used. A value must be specified for at least one WEP
encryption key if you specify 40-bit or 128-bit WEP
encryption for the security type.
Important • Be careful to include the exact number of
commas required for this command when setting
encryption keys (parameters
e through h). A missing
or extra comma will cause the keys to be stored in the
wrong slots and can prevent the printer from joining
the wireless network.
The encryption mode affects what can be entered for the
encryption keys:
• For 40-bit, encryption keys can be set to any 5 hex pairs
or any
10 alphanumeric characters.
•
For 128-bit, encryption keys can be set to any 13 hex
pairs or any 26 alphanumeric characters.
Note • When using hex storage, do not add a leading
0x on the WEP key.
Accepted Values: The actual value for the encryption key
Default Value: None
i = user ID*
Specifies a user ID for security types that require one.
A
value must be specified if using the following security
types:
• EAP-TTLS
•LEAP
• WPA LEAP
•PEAP
•WPA PEAP
• WPA EAP-TTLS
•Kerberos
Accepted Values: The actual value for the user ID.
Default Value: user
Parameters Details
* Not used for all security types