User guide

ZPL Commands for Wireless Operation
^WX
116
14143L-005 Rev. A Wireless User Guide 4/29/08
The following table identifies the parameters for this format.
Parameters Details
a = security type
Enter the two-digit code for the security type that your
WLAN uses. For which supporting parameters (b through n)
to use with the different security types, see Supporting
Parameters for Different Security Types on page 119.
Note • Configuring the printer for WPA also allows
the printer to be used in WPA2 environments.
Accepted Values: 01 to 15
01 = No wireless security is active
02 = WEP 40-bit
03 = WEP 128-bit
04 = EAP-TLS
05 = EAP-TTLS
06 = EAP-FAST
07 = PEAP
08 = LEAP
09 = WPA PSK (Key rotation for WPA2 PSK is
supported in firmware version V60.15.7Z,
V53.15.7Z, R6x15.x, R53.15.x, ZSPx, and later.)
10 = WPA EAP-TLS
11 = WPA EAP-TTLS
12 = WPA EAP-FAST
13 = WPA PEAP
14 = WPA LEAP
15 =Kerberos
Default Value: 01
b= WEP encryption
index*
Specifies which encryption key to use for WEP encryption. A
value must be specified if using WEP 40-bit or WEP 128-bit.
Accepted Values: 1, 2, 3, 4
Default Value: 1
c = WEP authentication
type*
Enables the WEP key authentication type. A value must be
specified if using WEP 40-bit or WEP 128-bit.
Accepted Values: O
or S
O = open system
S = shared key
Default Value: O
d = WEP key type*
Specifies the format of the WEP key. A value must be
specified if using WEP 40-bit or WEP 128-bit.
Accepted Values: H or S
H = hex key storage
S = string key storage
Default Value: S
* Not used for all security types