User guide

113
ZPL Commands for Wireless Operation
^WS
4/29/08 Wireless User Guide 14143L-005 Rev. A
^WS
Set Wireless Radio Card Values
Description Use this command to set the wireless radio card values for ESSID, Operating
Mode, and Card Preamble.
Format ^WSe,o,p,h,i,j,k
The following table identifies the parameters for this format.
Parameters Details
e =ESSID value Accepted Values: Any value up to 32 characters, including all
ASCII and Extended ASCII characters, including the space
character. When this parameter is left blank, the ESSID is not
changed.
Default Value: 125
o = operating mode Accepted Values: I (Infrastructure), A (Adhoc)
Default Value: I
p = wireless radio card
preamble
Accepted Values: L (Long), S (Short)
Default Value: L
h = wireless pulse
This parameter is
supported in firmware
version V60.15.x,
V50.15.x, R6x.15.x,
R53.15.x, ZSPx, or later.
Adds a pulse to the network traffic generated by the printer.
This pulse is necessary with some network configurations to
keep the printer online.
Accepted Values: 1 (Enabled), 0 (Disabled)
Default Value: 1
i = wireless pulse
interval
This parameter is
supported in firmware
version V60.15.x,
V50.15.x, R6x.15.x,
R53.15.x, ZSPx, or later.
Sets the interval at which the wireless pulse is sent when the
wireless pulse feature is enabled.
Accepted Values: 5 to 300 seconds
Default Value: 15