User guide

ZPL Commands for Wireless Operation
^WP
110
14143L-005 Rev. A Wireless User Guide 4/29/08
^WP
Set Wireless Password
Description Use this command to set the four-digit wireless password (not the same as the
general printer password). If the wireless password is 0000, the Wireless and Wireless Plus
print servers run in an “unprotected” mode, which means that you do not need to enter the
wireless password through the control panel to view or modify wireless settings.
If a wireless password is set, the values for the following parameters will not appear through
the control panel until the wireless password is entered:
• MAC Address
• ESSID
•WLAN Security
•WEP Type
•WEP Index
•Reset Network
Format ^WPa,b
The following table identifies the parameters for this format.
Note • This command does not apply to the S4M.
Parameters Details
a = old wireless
password
Accepted Values: 0000 through 9999
Default Value: 0000
b = new wireless
password
Accepted Values: 0000 through 9999
Default Value: 0000