User guide

ZPL Commands for Wireless Operation
^WL
108
14143L-005 Rev. A Wireless User Guide 4/29/08
^WL
Set LEAP Parameters
Description Use this command to enable Cisco
®
Lightweight Extensible Authentication
Protocol (LEAP) mode and set parameters. LEAP is user authentication method that is
available with some wireless radio cards.
Format ^WLa,b,c
The following table identifies the parameters for this format.
Note • The ^WL command is provided only for backward-compatibility with printers using
firmware prior to V50.15.x or X60.15.x. For these firmware versions and later, use ^WX
on page 115 to set the security type and related parameters.
Parameters Details
a =mode Accepted Values: OFF, ON
Default Value: OFF
b =user name Accepted Values: 0 to 32 ASCII characters
Default Value: user
c = password Accepted Values: 0 to 32 ASCII characters
Default Value: password