User guide

ZPL Commands for Wireless Operation
^WI
106
14143L-005 Rev. A Wireless User Guide 4/29/08
^WI
Change Wireless Network Settings
Description Use this command to change the wireless network settings. On Zebra
ZM400/ZM600™ and S4M™ printers running V53.15.xZ or later or on RZ400/RZ600™
printers running R53.16.x or later, Zebra recommends using ^ND on page 97 for these settings.
Format ^WIa,b,c,d,e,f,g,h,i
The following table identifies the parameters for this format.
Parameters Details
a = IP resolution Accepted Values:
A =All
B =BOOTP
C = DHCP and BOOTP
D = DHCP
G = Gleaning only (Not recommended when the
Wireless Print Server or Wireless Plus Print Server
is installed.)
R =RARP
P = Permanent
Default Value: A
b = IP address Accepted Values: Any properly formatted IP address in the
xxx.xxx.xxx.xxx format.
Default Value: 000.000.000.000
c = subnet mask Accepted Values: Any properly formatted subnet mask in the
xxx.xxx.xxx.xxx format.
Default Value: 000.000.000.000
d = default gateway Accepted Values: Any properly formatted gateway in the
xxx.xxx.xxx.xxx format.
Default Value: 000.000.000.000
e = WINS server address Accepted Values: Any properly formatted WINS server in the
xxx.xxx.xxx.xxx format.
Default Value: 000.000.000.000
f = connection timeout
checking
Accepted Values:
Y = yes
N = no
Default Value: Y
g = timeout value
Time, in seconds, before the connection times out.
Accepted Values: 0 through 9999
Default Value: 300