User guide

ZPL Commands for Wireless Operation
^NP
100
14143L-005 Rev. A Wireless User Guide 4/29/08
^NP
Set Primary/Secondary Device
Description Use this command to specify whether to use the printer’s or the print server’s
LAN/WLAN settings at boot time. The default is to use the printer’s settings.
When the printer is set as the primary device, you can set it up using ZPL commands or the
Wireless Setup Wizard utility, and any wired print server inserted into the printer will use those
settings. The drawbacks to using the printer as primary are:
• Any wired print server inserted into the printer will lose its original settings if the printer is
set to check for the wired print server (see
^NB on page 95)
• GLEANING ONLY for IP PROTOCOL will no longer work.
Format ^NPa
The following table identifies the parameters for this format.
Parameters Details
a = device to use as
primary
Accepted Values:
P = PRINTER
M = MPS/PRINTSERVER
Default Value: P