User guide

About This Document
Who Should Use This Document
10
14143L-005 Rev. A Wireless User Guide 4/29/08
Who Should Use This Document
This User Guide is intended for use by someone who needs to configure and use a wireless
print server for use with a supported printer.
This version of the User Guide supports the ZebraNet Wireless Print Server, the ZebraNet
Wireless Plus Print Server, and the ZebraNet Internal Wireless Plus Print Server with printer
firmware versions X.15.x or later. Some features require X.16.x or later.
The following special versions of firmware or later also are supported. They are referred to in
this User Guide as ZSPx firmware.
• ZSP994P
• ZSP999F
• ZSP1027F
• ZSP1056E
• ZSP1082F
For older versions of firmware, refer to the Wireless Print Server User Guide, part number
13422L-XXX.
How This Document Is Organized
The User Guide is set up as follows:
Section Description
Introduction on page 15 This section provides an overview of the ZebraNet wireless print
servers, including the Wireless Print Server, Wireless Plus Print
Server, and Internal Wireless Plus Print Server.
Configuration on page 29 Use the instructions in this section to configure your ZebraNet
wireless print server for operation.
Wireless Status and Settings
on page 43
This section presents several options for viewing or modifying the
wireless status, signal strength, or settings. You may also use:
Troubleshooting on page 57 This section provides solutions to problems related specifically to
the wireless print servers.
WebView Web Pages on page 63 This section provides you with instructions for viewing the current
print server settings.
ZPL Commands
for Wireless Operation on page 93
This section contains ZPL commands for configuring and running
the ZebraNet wireless print servers.
SGD Wireless Commands on page 125 This chapter provides a high-level overview of the wireless Set /
Get / Do (SGD) commands and details on each SGD command.