User guide

ZPL Commands for the Wireless Print Server
^WP
46
13422L-002 Rev. B Wireless Print Server User Guide 9/29/05
^WP
Set Wireless Password
Description This command sets the four-digit wireless password (not the same as the
general printer password). If the wireless password is 0000, the Wireless Print Server runs in
an “unprotected” mode, which means that you do not need to enter the wireless password
through the control panel to view or modify wireless settings.
If a wireless password is set, the values for the following parameters will not appear through
the control panel until the wireless password is entered:
• MAC Address
• ESSID
• Auth Type
• Leap Mode (if applicable)
• Encryption Mode
• Encryption Index
•Reset Network
Format
^WPa,b
The following table identifies the parameters for this format.
Note • This command does not apply to the S4M.
Parameters Details
a = old wireless password
Accepted Values: 0000 through 9999
Default Value: 0000
b = new wireless password
Accepted Values: 0000 through 9999
Default Value: 0000