User guide

43
ZPL Commands for the Wireless Print Server
^WI
9/29/05 Wireless Print Server User Guide 13422L-002 Rev. B
^WI
Change Wireless Network Settings
Description Use this command to change the wireless network settings.
Format ^WIa,b,c,d,e,f,g,h,i
The following table identifies the parameters for this format.
Parameters Details
a = IP Resolution Accepted Values:
A (ALL)
B (BOOTP)
C (DHCP AND BOOTP)
D (DHCP)
G (GLEANING ONLY)
R (RARP)
P (PERMANENT)
Note • Use of GLEANING ONLY is not recommended when the Wireless
Print Server is installed.
b = IP Address Accepted Values: Any properly formatted IP address in the xxx.xxx.xxx.xxx
format.
c = Subnet Mask Accepted Values: Any properly formatted subnet mask in the xxx.xxx.xxx.xxx
format.
d = Default Gateway Accepted Values: Any properly formatted gateway in the xxx.xxx.xxx.xxx
format.
e = WINS Server Address Accepted Values: Any properly formatted WINS server in the xxx.xxx.xxx.xxx
format.
f = Connection Timeout
Checking
Accepted Values: Y (YES), N (NO)
g = Timeout Value
Time, in seconds, before the connection times out.
Accepted Values: 0 through 9999
h = ARP Broadcast
Interval
Time, in minutes, that the broadcast is sent to update devices ARP cache.
i = Base Raw Port Number
The port number that the printer should use for its RAW data.
Accepted Values: 0 through 99999
Default Value: 9100