User guide

ZPL Commands for the Wireless Print Server
^NP
36
13422L-002 Rev. B Wireless Print Server User Guide 9/29/05
^NP
Set Primary/Secondary Device
Description This command specifies whether to use the printer’s or the print server’s
LAN/WLAN settings at boot time. The default is to use the printer’s settings.
When the printer is set as the primary device, you can set it up using ZPL commands or the
SetWLAN utility, and any wired print server inserted into the printer will get these settings.
The drawbacks to using the printer as primary are that any wired print server inserted into the
printer will lose its original settings if the printer is set to check for the wired print server (see
^NB on page 34) and that using GLEANING ONLY for IP PROTOCOL will no longer work.
Format
^NPa
The following table identifies the parameters for this format.
Parameters Details
a = Device to Use as
Primary
Accepted Values: P (PRINTER), M (MPS/PRINTSERVER)