User guide

Wireless Status and Settings

Return Network Parameters to Defaults

13422L-002 Rev. B Wireless Print Server User Guide 9/29/05

Return Network Parameters to Defaults

You may need to return the network parameters to the factory defaults under the following

circumstances:

• If you download a different version of firmware to your printer

• If you need to reset the encryption keys (for instances where a key was entered incorrectly

or was forgotten)

After you return the parameters to the defaults, you will need to reconfigure your printer to use

the Wireless Print Server (see Configuration on page 7). If you saved the ZPL script generated

by the SetWLAN utility, simply send this file to the printer and then power cycle the printer. If

you were using a wireless password, you need to set it again (see ^WP on page 46).

You can set the network parameters back to the factory defaults in two ways:

• (All printers) The Restore Default Network Configuration button on the printer’s View

and Modify Printer Settings Page (see Figure 12 on page 27).

• (For printers other than the S4M) The

DEFAULT NET option, which appears as an option

when you exit Setup mode. Refer to the user guide for your printer for specific

instructions on how to use the control panel.

Note • The LOAD DEFAULTS option and the Restore Default Configuration button on

the printer’s View and Modify Printer Settings Page reset all printer parameters other than

network settings back to factory defaults. The network settings will not change when these

options are selected.