User guide

Wireless Status and Settings
View or Change Control Panel Parameters for the Wireless Print Server
24
13422L-002 Rev. B Wireless Print Server User Guide 9/29/05
Parameters for the S4M Printer
Table 4 shows the wireless parameters that may be viewed or modified through the printer’s
control panel if you have the Wireless Print Server installed on an S4M and are operating in
ZPL or EPL mode. These parameters are considered part of the Level 3 password. To view
network parameters that are not available as selections through the control panel, print a
network configuration label.
Note • Refer to the S4M User Guide for specific instructions on how to use the control panel.
Table 4 • Control Panel Parameters for
the ZebraNet Wireless Print Server (S4M only)
Parameter Explanation
PRINT OUT
NETWORK
This selection is used to print a network configuration label (see Figure 11
on page 20).
OBTAIN IP ADDRESS
Obtain an IP Address
Selects the method by which an IP address will be assigned to the printer.
If you choose
AUTO SELECT, you may specify an IP protocol (see
Change the IP Protocol on page 25).
Selections: AUTO SELECT (dynamic), PERMANENT (user-specified)
Default Value: AUTO SELECT
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
CHANGE IP ADDRESS
View or Change the Printer’s IP Address
This parameter can be modified only when
PERMANENT is selected for
OBTAIN IP ADDRESS.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note • Leading zeroes are not shown in the address. If an IP
address contains more digits than can be displayed at one time, use
the left or right arrows to scroll through the digits.
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.