User guide

23
Wireless Status and Settings
View or Change Control Panel Parameters for the Wireless Print Server
9/29/05 Wireless Print Server User Guide 13422L-002 Rev. B
LEAP MODE
3,4
Enable LEAP Mode
An encryption method that is available with some wireless cards. Set the
LEAP user name and password through the printer web pages (see
WebView Web Pages on page 55) or by ZPL (see ^WL on page 44). By
default, LEAP user will be set to user, and LEAP password will be set to
password.
Accepted Values: ON, OFF
Default Value: OFF
ENCRYPTION MODE
2,3
Set Encryption Mode
Accepted Values: OFF, 40-BIT, 128-BIT
Default Value: OFF
ENCRYPT. INDEX
2,3
Select an Encryption Index
Accepted Values: 1, 2, 3, 4
Default Value: 1
RESET NETWORK
1,3
Reset the Wired or Wireless Network
Reinitializes the wired or wireless network. Also causes any wireless card
in the printer to reassociate to the wireless network. (Same function as
ZPL command ~WR on page 48.)
Table 3 • Control Panel Parameters for the ZebraNet Wireless Print Server
(printers other than the S4M) (Continued)
Parameter
Function
1 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
2 Appears only when the ZebraNet Wireless Print Server is installed.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.