User guide
Wireless Status and Settings
View or Change Control Panel Parameters for the Wireless Print Server
22
13422L-002 Rev. B Wireless Print Server User Guide 9/29/05
IP PROTOCOL
1
Obtain an IP Address
This parameter allows either the user (permanent) or the server (dynamic)
to select the IP address. If a dynamic option is chosen, this selection
determines the method(s) by which the print server (wired or wireless)
receives the IP address from the server.
Accepted Values: ALL, GLEANING ONLY, RARP, BOOTP, DHCP,
DHCP AND BOOTP, PERMANENT
Default Value: All
Note • Use of GLEANING ONLY is not recommended when the Wireless
Print Server is installed.
IP ADDRESS
1
View or Change the Printer’s IP Address
This parameter can be modified only when PERMANENT is selected for
IP PROTOCOL.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
SUBNET MASK
1
View or Change the Subnet
This parameter can be modified only when PERMANENT is selected for
IP PROTOCOL.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
DEFAULT GATEWAY
1
View or Change the Gateway
This parameter can be modified only when PERMANENT is selected for
IP PROTOCOL.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
MAC ADDRESS
2,3
View MAC Address
This parameter shows the MAC address of the current wireless card.
Default Value: 000000000000
ESSID
2,3
Set ESSID
Default Value: 125
AUTH. TYPE
2,3
Set Authentication Type
Accepted Values: OPEN, SHARED
Default Value: OPEN
Table 3 • Control Panel Parameters for the ZebraNet Wireless Print Server
(printers other than the S4M) (Continued)
Parameter
Function
1 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
2 Appears only when the ZebraNet Wireless Print Server is installed.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.