User guide

Wireless Status and Settings

Wireless Network Parameters on the LCD

14143L-008 Rev. B Wireless User Guide 2/16/11

Other Printer Models

Table 13 shows the wireless parameters that may be viewed or modified through the control

panel on the following printers:

•Non-RFID—105SL, PA X 4, XiIIIPlus, Z4Mplus, Z6Mplus

•RFID—R110PA X4, R4Mplus, R110Xi, R170Xi, R110Xi HF

Printers with older versions of firmware have a different set of parameters. For those

parameters, refer to the ZebraNet Wireless Print Server User Guide. You may download

firmware V60.15.x, R6x.15.x, or later to access the newer encryption features. Go to

http://www.zebra.com/firmware for firmware download options.

Table 13 • Wireless Parameters for Other Printer Models

Parameter

Function

WIRED PS CHECK? View if the Printer Checks for a Wired Print Server at Bootup

This parameter tells if the printer searches for a wired print server at

bootup.

Selections: YES, NO

Default Value: NO

Corresponding ZPL Command: ^NB

Corresponding SGD Command: none

LOAD LAN FROM? View if IP Settings Are Loaded from the Printer or Print Server

This parameter, which serves the same function as the

^NP ZPL command,

tells if the printer uses IP settings from the printer or the print server at

bootup.

Selections: PRINTER, PRINTSERVER

Default Value: PRINTER

Corresponding ZPL Command: ^NP

Corresponding SGD Command: none

IP PROTOCOL View or Change the IP Resolution Method

This parameter tells if the user (permanent) or the server (dynamic) selects

the IP address. If a dynamic option is chosen, this parameter tells the

method(s) by which the print server (wired or wireless) receives the IP

address from the server.

Selections: ALL, BOOTP, DHCP, DHCP AND BOOTP, PERMANENT

Default Value: All

Corresponding ZPL Command: ^WI

Corresponding SGD Command: wlan.ip.protocol

IP ADDRESS View the Printer’s IP Address

Default Value: 0.0.0.0 displays while an IP address is being obtained, and

then defaults to 192.168.254.254 if no IP address is obtained

Corresponding ZPL Command: ^WI

Corresponding SGD Command: wlan.ip.addr

1 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.