User guide

Wireless Status and Settings
Wireless Network Parameters on the LCD
40
14143L-008 Rev. B Wireless User Guide 2/16/11
CHANGE SUBNET
View or Change the Subnet
This parameter can be modified only when
PERMANENT is selected for
OBTAIN IP ADDRESS.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note • Leading zeroes are not shown in the address. If an IP address
contains more digits than can be displayed at one time, use the left
or right arrows to scroll through the digits.
Corresponding ZPL Command: ^ND
Corresponding SGD Command: ip.netmask
CHANGE GATEWAY
View or Change the Gateway
This parameter can be modified only when
PERMANENT is selected for
OBTAIN IP ADDRESS.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note • Leading zeroes are not shown in the address. If an IP address
contains more digits than can be displayed at one time, use the left
or right arrows to scroll through the digits.
Corresponding ZPL Command: ^ND
Corresponding SGD Command: ip.gateway
Password Level 4 Parameters
MAC ADDRESS
1
View the Wireless Radio Card’s MAC Address
Each wireless radio card has a permanent and unique Media Access
Control (MAC) address assigned to it. This parameter shows the MAC
address for the current wireless radio card.
Default Value: 000000000000
Corresponding ZPL Command: none
Corresponding SGD Command: card.mac_addr
ESSID
1
View the ESSID Value
The Extended Service Set Identification (ESSID) is an identifier for your
wireless network. This parameter shows the ESSID for the current wireless
configuration.
Default Value: 125
Corresponding ZPL Command: none
Corresponding SGD Command: wlan.essid
WLAN SECURITY
1
View the WLAN Security Type
This parameter displays the current security type.
Corresponding ZPL Command: ^WX
Corresponding SGD Command: wlan.security
Table 12 • Wireless Parameters for S4M Printers (Continued)
Parameter Explanation
1 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.