User guide

37
Wireless Status and Settings
Wireless Network Parameters on the LCD
2/16/11 Wireless User Guide 14143L-008 Rev. B
SUBNET MASK View or Change the Subnet
This parameter can be modified only when
PERMANENT is selected for
IP PROTOCOL.
Selections: 0 to 255 for each field
Default Value: 255.255.255.0
Note • Leading zeroes are not shown in the address.
Corresponding ZPL Command: ^ND
Corresponding SGD Command: ip.netmask
DEFAULT GATEWAY View or Change the Gateway
This parameter can be modified only when
PERMANENT is selected for
OBTAIN IP ADDRESS.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note • Leading zeroes are not shown in the address.
Corresponding ZPL Command: ^ND
Corresponding SGD Command: ip.gateway
MAC ADDRESS View the Wireless Radio Card’s MAC Address
Each wireless radio card has a permanent and unique Media Access
Control (MAC) address assigned to it. This parameter shows the MAC
address for the current wireless radio card.
Default Value: 000000000000
Corresponding ZPL Command: none
Corresponding SGD Command: card.mac_addr
ESSID View the ESSID Value
The Extended Service Set Identification (ESSID) is an identifier for your
wireless network. This parameter shows the ESSID for the current wireless
configuration.
Default Value: 125
Corresponding ZPL Command: none
Corresponding SGD Command: wlan.essid
Table 11 • Wireless Parameters for Xi4, R110Xi4,
ZM400, ZM600, RZ400, and RZ600 Printers (Continued)
Parameter
Function
1 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.