User guide

Wireless Status and Settings

Wireless Network Parameters on the LCD

2/16/11 Wireless User Guide 14143L-008 Rev. B

Wireless Network Parameters on the LCD

The control panel parameters are somewhat different for different printers. Refer to the User

Guide for your printer for specific instructions on how to modify the control panel parameters.

To view wireless and network parameters that are not available as selections through the

control panel, print a network configuration label.

The network parameters do not appear until after the printer recognizes the existence of a

ZebraNet print server (wired or wireless). All zeroes (000.000.000.000) may display for some

parameters until the printer obtains an IP address.

Wireless Password Some of the parameters can be password-protected by a wireless

password. By default, the wireless print servers run in an “unprotected” mode (password set to

0000), which means that you do not need to enter a wireless password through the control

panel to view or modify wireless settings. To set a wireless password (not the same as the

general printer password), use the ^WP ZPL command or the wlan.password SGD

command.

Xi4, R110Xi4, ZM400, ZM600, RZ400, and RZ600 Printers

Table 11 shows the wireless parameters that may be viewed or modified through the control

panel on the Xi4, R110Xi4, ZM400, ZM600, RZ400, and RZ600 printers.

Note • The HC100 printer does not have an LCD. To view or change the wireless

parameters, use the printer’s web pages, ZPL commands, or SGD commands.

Table 11 • Wireless Parameters for Xi4, R110Xi4,

ZM400, ZM600, RZ400, and RZ600 Printers

Parameter

Function

PRIMARY NETWORK

Select the Primary Network Device

This parameter determines which device should be considered primary in

the active device selection. See Active Device Selection on page 22 for

more information.

Selections: WIRED, WIRELESS

Default Value: WIRED

Corresponding ZPL Command: ^NC

Corresponding SGD Command: none

LOAD FROM EXT?

View if IP Settings Are Loaded from the Printer or Print Server

This parameter tells whether to use the printer’s or the print server’s

LAN/WLAN settings at boot time. The default is to use the printer’s

settings.

Selections: YES, NO

Default Value: NO

Corresponding ZPL Command: ^NP

Corresponding SGD Command: none

1 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.