Service manual

6 TTPM2 Operators’ Guide October, 01
2.2 Operator controls
The front panel has three buttons and three indicators with the following functions.
Green indicator
Fixed:
Blinking:
Flickering:
Temporarily OFF:
Power ON & printer ready.
Insert ticket.
Receiving data.
Commands are executed.
Yellow Indicator
Fixed: Out of paper.
Blinking: Print command
received, but out of paper.
Red indicator
Error, turn OFF
and ON the printer
to clear.
Front pushbutton
1.Cuts and ejects a ticket .
2. Press and hold at power ON to enter
self test mode. Press again to encode
and print one ticket. The printout
shows current firmware version. Turn
printer OFF and ON to exit self test
mode.
Center pushbutton
Ejects any document in
the selected ticket track.
(Same as when an !E
command is received.)
Rear pushbutton
Press and hold at power ON to turn on paper
jam clearing mode. Press front button to
advance ticket forward and middle button to
retract ticket backwards. Turn printer OFF
and ON to exit paper jam clearing mode.
SW97108
1
2
Figure 2. Indicators and pushbuttons
Using the buttons and indicators will be further explained later in this manual.
1
1
Do not hold the front button depressed! Doing so will result in erroneously cut tickets often resulting in paper jam.
2
On CD 200 versions, load new ticket stock, then press the center pushbutton.