Service manual

18 TTPM2 Operators’ Guide October, 01
5 CORRECTIVE ACTIONS
5.1 General reset
A general reset of the TTPM2, restoring all parameters to their default value, is effected if
all three pushbuttons are kept depressed at power ON. All three indicators will light but
nothing else will happen. At this point, the power has to be turned OFF and ON once
more. The TTPM2 is then reset.
5.2 Paper jam removal
Open the TTPM2 cover to locate and remove the ticket that is stuck in the mechanism.
Use the following procedure:
5.2.1 Select paper jam clearing mode
1. Power OFF.
2. Push and hold the rear pushbutton while turning ON the power. The red indicator
shows a steady light to indicate paper jam clearing mode.
5.2.2 Tickets stuck in rear of the printer
Press and hold the center push button to eject the ticket towards the rear of the unit.
5.2.3 Tickets stuck in front part of the printer
Press and hold the front push button to eject the ticket towards the front of the unit.
5.2.4 Exit paper jam clearing mode
Power OFF and back ON again, the TTPM2 is operational but any ticket information pre-
viously sent to the unit is lost.
5.2.5 Manual cranking
You can also power OFF the printer
and turn the feed rolls manually to
remove the blocking ticket.